By continuing your navigation on this site, you accept the use of cookies to offer you contents and adapted services. Legal Notice.
 
 
 
Close

Do It Yourself

My Modular Synth

Contact

Visits

   visitors

   visitors online

Wavemorpher

The wave generator from RSF Kobol start from a triangle and by continuous morphing go through a Saw, a Square and a Pulse. The triangle amplitude is lower than others waves.

The principle is the same as a CV panner where 2 Otas are driven in opposite phase. The remaining circuit is here to control level, offset... to get something usable.

You could look into the download section under modules a video to give you an idea of the result.

You have 2 trimmers to adjust.  Put a Saw in to about 500Hz no matter the frequency, put the potentiometer fully CCW and adjust RV101  to get a good triangle then push the pot fully CW and adjust RV104 to get the smallest pulse and that's all.

drawing :          

Pcb :                

Layout:            

Bom :             


Creation date : 19/07/2014 - 18:23
Last update : 20/07/2014 - 12:35
Page read 4331 times